Installing a Brick Paver Walkway or Red Wall Bricks

The use of Bricks or Pavers to create a sidewalk or outdoor patio complements a house in a way that is unequaled. In addition, setting up a Brick or Paver pathway does not necessarily need a pro.

The key to setting up a Brick or Paver Walkway is to first correctly prepare the location where the bricks/pavers are to be installed. The location must be dug out a minimum of a foot down, removing all topsoil and clay soil. In addition, string lines must be strung on each side of the walkway. The string lines show the finished height of the sidewalk.
Once the location has actually been dug down, 3/4" gravel stone need to be laid in and tamped down firmly. 2" of sand, or stone dust should be spread over the gravel. Once again the sand/stone dust must be tamped down. Stone dust is preferred. The height between the tamped down sand and the stringline need to equal the thickness of the brick or paver.

Now that you have a steady base, position a 1" pipeline or ledger board the length of the sidewalk on either side of the pathway. Then using a flatedge, e.g. a 2"x4" board, slide it over the two lengths of the pipe/ledger board. In doing this you will develop a level area to lay the bricks/pavers.

Now place on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the prepared area. These strips will act as your sidewalk border and assistance to keep the stability and shape of the sidewalk.

The secret to laying the bricks/pavers is to ensure that they interlock with each other. Constantly stagger adjacent rows of bricks by 1/2 of a brick to check here interlock them. This will once again help preserve the stability of the walkway.

Undoubtedly bricks/pavers will require to be cut or divided when building big grey bricks the pathway. To really cut/split the brick/paver, lay it in a bed of sand and location the sculpt at a 75 degree angle over the area where you desire to break the brick. If your walkway has curves you will require to buy/rent a wetsaw.

After setting up the bricks, build up the outside edges with additional sand, and then shovel in the topsoil and load down firmly.
Finally, spread stone dust over the new walkway and sweep into the cracks. Repeat this procedure a number of times to ensure the fractures are totally filled. This will finish the interlocking of the bricks and assist to remove any weed development. Just add turf seed to the outside edges and you ought to have a lovely entryway to your home within a couple of weeks.


In addition, installing a Brick or Paver walkway does not always need a pro. The key to installing a Brick or Paver Walkway is to very first effectively prepare the area where the bricks/pavers are to be installed. Now that you have a stable base, put a 1" pipeline or journal board the length of the sidewalk on either side of the pathway. These strips will act as your pathway border and assistance to keep the stability and shape of the sidewalk. Undoubtedly bricks/pavers will require to be cut or split when building the sidewalk.

Leave a Reply

Your email address will not be published. Required fields are marked *