The use of Bricks or Pavers to develop a pathway or patio matches a home in a method that is unequaled. In addition, installing a Brick or Paver sidewalk does not necessarily need a pro.
The key to setting up a Brick or Paver Walkway is to first appropriately prepare the location where the bricks/pavers are to be set up. In addition, string lines need to be strung on each side of the walkway.
When the location has actually been dug, 3/4" gravel stone need to be laid in and tamped down securely. 2" of sand, or stone dust must be spread over the gravel. Again the sand/stone dust must be tamped down. Stone dust is preferred. The height between the tamped down sand and the stringline ought to equate to the density of the brick or paver.
Now that you have a stable base, position a 1" pipe or ledger board the length of the sidewalk on either side of the pathway. Using a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will develop a level surface area to lay the bricks/pavers.
Now place on the level sand/stone dust strips of plastic brick borders. Install a run on both sides of the prepared location. These strips will act as your sidewalk border and help to maintain the integrity and shape of the sidewalk.
The key to laying the bricks/pavers is to ensure that they interlock with each other. Always stagger adjacent rows of bricks by 1/2 of a brick to interlock them. This will click here again assist preserve the integrity of the pathway.
Inevitably bricks/pavers will need to be cut or split when constructing the sidewalk. Unless you want to buy or lease an expensive wetsaw, I would recommend purchasing an easy brick/paver splitter. It is generally a sculpt with a large end that is the width of the bricks/pavers. To really cut/split the brick/paver, lay it in a bed of sand and place the sculpt at a 75 degree angle over the area where you desire to break the brick. Then utilizing a hammer strike the butt end of the sculpt firmly. You might need to do this a couple website of times. You might also want to flip the brick/paver over and strike the opposite of the brick utilizing the hammer and chisle. Within a couple of strikes the brick/paver should break easily. , if your sidewalk has curves you will require to buy/rent a wetsaw.
.
After setting up the bricks, build up the outdoors edges with additional sand, and after that shovel in the topsoil and pack down securely.
Spread stone dust over the new walkway and sweep into the cracks. This will complete the interlocking of the bricks and help to eliminate any weed development.
In addition, installing a Brick or Paver pathway does not necessarily require a pro. The key to installing a Brick or Paver Walkway is to very first properly prepare the location where the bricks/pavers are to be installed. Now that you have a stable base, put a 1" pipe or ledger board the length of the pathway on either side of the sidewalk. These strips will act as your sidewalk border and aid to maintain the integrity and shape of the pathway. Undoubtedly bricks/pavers will require to be cut or divided when constructing the sidewalk.